Key takeaways
- Dig a wide, shallow hole, and plant so the root flare sits at ground level.
- Remove wire, twine and burlap from the top of the root ball.
- Stake only if the tree cannot stand on its own, and remove stakes within about a year.
- Water deeply and regularly for the first couple of years.
Planting a tree takes less digging than most people think, but a few details matter a lot.
Dig wide, not deep
The hole should be two to three times as wide as the root ball and no deeper than the ball. Roots spread sideways near the surface. A wide hole with loosened soil helps them move out.
Find the root flare
The flare is the point where the trunk widens into roots. It should be at or slightly above the soil line. Trees planted too deep can decline slowly over years. If the flare is buried in the pot, remove soil from the top until you find it.
Prepare the roots
Remove any wire basket, twine and plastic. If the roots circle the pot, tease or cut them so they grow outward. Burlap on the top of the ball should be cut away.
Backfill and water
Use the soil you dug out. Fill halfway, water to settle, then finish filling. Avoid stomping hard. Build a small ring of soil to hold water.
Mulch
Spread two to four inches of mulch in a wide ring, and keep it a few inches back from the trunk.
Staking
Many trees do better without stakes. If the tree cannot stand on its own or the site is windy, use soft ties and allow movement. Remove stakes within about a year.
Water, water, water
For the first couple of years, water deeply and regularly during dry periods. A slow soak is better than a quick sprinkle.
Related services
Questions about your own trees? Call or text 800-224-9245, or use the quote form below.
